Table of Contents
Advertisement
GENERAL ASSEMBLY INSTRUCTIONS
1
2
5
6
WARNING:
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE VACUUM. TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank and remove the pre-filter (Fig. 3).
4. Remove the contents from inside the collection tank and the box; make sure you have all
contents as listed in carton content list on page 5.
5. For improved dust filtration, fit the dust bag flange onto the inlet port, taking care not to
damage the bag (Fig. 4).
6. Place the pre-filter onto the rim of the collection tank. Make sure the edge of the filter fits
snugly along the edge of the collection tank (Fig. 5).
NOTE: Ensure the dust collection bag and the pre-filter are correctly installed before each use.
7. With the filters installed, place the power head onto the collection tank and secure it with the
latches (Fig. 6 & 7).
8. Insert the locking end of the hose into the vacuum port of the collection tank and turn
clockwise to lock into place (Fig. 8).
9. Choose the desired attachment and insert onto the end of hose or extension wand (Fig. 9).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do
not change the plug in any way.
Ⅰ
7
DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
3
Ⅱ
Ⅰ
Ⅱ
6
4
4
8
9
Advertisement
Table of Contents
