Troubleshooting ___________________________________________________________ 10 Thank you for purchasing this Vacmaster® wet and dry vacuum cleaner. Feel confident that with Vacmaster® you are obtaining a high quality product engineered for optimal performance. This vacuum cleaner is capable of picking up liquids and dry materials.
In addition, it is possible that it will not be Vacmaster® takes pride in producing a high quality, durable product. This completely filtered out by the filter system of the wet and dry vacuum cleaner and Vacmaster®...
• Don’t try to repair the appliance yourself. Always use a qualified technician for repairs. Always have faulty power cords replaced immediately by the manufacturer PECIFICATIONS or a qualified electrician. Use the same type of cable in order to prevent any danger of electric shock and injury.
CAUTION: • Do not vacuum drywall dust or fireplace soot or ash. This is a very fine dust which will NPACKING AND CHECKING CARTON CONTENTS not be captured by the filter and may cause damage to motor and void the warranty. Remove entire contents of carton.
ENERAL ASSEMBLY INSTRUCTIONS Handle Cord Rewind Button WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET, MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET AND DRY VACUUM Power Switch Power Head CLEANER UNPACKING YOUR WET AND DRY VACUUM CLEANER & GENERAL ASSEMBLY 1.
4. Optional, for improved dust filtering, fit dust bag flange onto the inlet stub, taking care not to damage the bag. (fig. 4) 5. Place the power head back on the container, aligning the top section with the latches, and lock into place. (fig. 5) OPERATING INSTRUCTIONS: DRY VACUUMING 6.
allow air inflow. The machine is fitted with a float valve that stops the suction action when the container reaches its maximum capacity. You will notice an ET-VACUUM OPERATION increase in motor noise. When this happens, turn off the machine, disconnect from power supply, and drain the liquid into a suitable receptacle or drain.
only. A dry cartridge filter is necessary to pick up dust. If the cartridge filter Installing and Cleaning HEPA Filter is wet, it will clog quickly and be very difficult to clean. Handle the filter 1.Verify that the power cord is disconnected from the power socket. (fig.1) carefully when removing it for cleaning and replacing it.
ROUBLESHOOTING Symptom Possible Causes Corrective Action 1) No power supply. 1) Check power supply – cord, breakers, fuses. Vacuum cleaner 2) Faulty power cord. 2) Unplug and check the will not operate power cord. If damaged, have it repaired by a professional. 3) Container full.