Connecting The Loudspeakers; Connecting The Dcs To The Npm - Honeywell X-618 Installation Manual

Figure 20 Schematic Diagram of the Noise Detector Connection

Connecting the Loudspeakers

The DCS can be directly connected to loudspeakers. The following steps describe this process:
1. Strip off the wire jacket of one end of the prepared audio cable by about 10mm, insert the
loudspeaker wiring terminal, and tighten the screws. Refer to Figure 13.
2. Insert the loudspeaker wiring terminal of the installed audio cable into the DCS loudspeaker
port. Refer to Figure 14.
3. Connect the loudspeaker to the other end of the audio cable, as shown in Figure 21.
Figure 21 Schematic Diagram of the Loudspeaker and Audio Cable Connection

Connecting the DCS to the NPM

The DCS and NPM can be connected in the following two ways:

Directly connecting the DCS to the NPM

Connecting the DCS to the NPM through a network switch
Directly Connecting the DCS to the NPM
Connect the DCS to the NPM using the RJ45 cable. The following describes this process:
Insert one end of the prepared RJ45 cable into the network port located on the rear panel of
the DCS, and the other end of the cable into the RJ45 port located on the rear panel of the NPM,
as shown in Figure 22.
16