Installation; Removal From Packaging; Locating The Machine; Serial Number - Kemppi PROMIG 200 ML Operation Instructions Manual

Mains voltage
Never take welding machine inside a work piece (eg. container or truck). Do not place
welding machine on a wet surface. Always check cables before operating the machine.
Change defect cables without delay. Defect cables may cause an injury or set out a fi re.
Connection cable must not be compressed, it must not touch sharp edges or hot work
pieces.
Welding power circuit
Isolate yourself by using proper protective clothing, do not wear wet clothing. Never
work on a wet surface or use defect cables. Do not put MIG-gun or welding cables on
welding machine or on other electric equipment. Do not press MIG-gun switch, if the
gun is not directed towards a work piece.
Welding fumes
Take care that there is suffi cient ventilation during welding. Take special safety precau-
tions when welding metals which contain lead, cadmium, zinc, mercury or beryllium.

2. INSTALLATION

2.1. Removal from packaging

The equipment is packed in a durable package specially designed for it. It is howe-
ver necessary to check the equipment before taking it in use, to make sure that the
equipment or a part of it have not got damaged during the transportation. Also check
that the delivery corresponds your order and that you have received all the necessary
instructions for installing and operating the equipment. The packaging material can be
recycled.

2.2. Locating the machine

Place the machine on a horizontal, stable and clean ground. Protect the machine from
heavy rain and burning sunshine. Check that there is enough space for cooling air circu-
lation in front of and behind the machine.

2.3. Serial number

The serial number of the machine is marked on the machine CE-marking. Identifi cation
of the serial number is the only proper means of maintaining and identifying parts for
a specifi c product. It is important to make correct reference to the serial number of the
product when making repairs or ordering spare parts.

2.4. Installation and main parts

2.4.1. Assembling the equipment

Fasten the units by using the screws and bolts delivered with the equipment. Install
welding gun and tighten carefully. Cable connections are presented in the following
chapters.
PROMIG 200ML/0509 – 4 © KEMPPI OY