Service the PA-5400 Series Firewall Hardware
For informaon on troubleshoong card slots and changing slot states, see
Firewall Networking Card (NC) Troubleshoong
State
Empty
Up
Disabled
HA-Disabled
Stopping
Starng
PowerOff
AdminPowerOff
Failure
Unsupported
PA-5400 Series Logical Card Slots
The PA-5400 Series firewall requires the use of logical card slots in order to direct processing
power from the Data Processing Card
A). For this to occur, an NC in Slot 1 of the appliance is logically paired to a DPC in Slot 3. Similarly,
an NC in Slot 2 of the appliance is logically paired to a DPC in Slot 4. Logical pairing of the NC
and DPC allows the appliance to process excepon packets and other data that the NC does not
process alone.
If you install a DPC in Slot 2 of the appliance, then there is no logical pairing with Slot 4.
PA-5400 Series Next-Gen Firewall Hardware Reference
Commands.
Descripon
The slot is empty and is ready to use.
The card is powered on and has a valid soware configuraon.
(HA
only) The slot is not enabled.
In a high availability (HA) configuraon, the NC slots stay in a
disabled state unl you enable the slot. This is by design, so you
can install new NCs without causing a failover. Aer you insert
matching NCs in both firewalls, you then bring up both cards
simultaneously.
(HA
only) Aer you enable a slot, this status appears unl both
slots are ready.
This also occurs if the peer does not have a matching card in the
same slot number or the card in the peer is not ready.
The card is preparing for removal.
The card is in the process of powering on and the soware is
iniang.
The card is powered down and ready for removal.
An administrator powered down the slot and it will not be
available unl you power it back on. If there is a slot that you
want ignored in an HA configuraon HA, put it in this state.
The card has failed and needs to be replaced.
The card is not a supported type for this slot.
(PA-5400
DPC-A) to the Networking Card
76
PA-5400 Series
(PA-5400 NC-
2021 Palo Alto Networks, Inc.
©