Advertisement
17. Use 2 M4*8 screws to fix filament fixed seat
in the back.
19. Find [Z-axis motor cable] on both sides marked with [Z-Steeper], insert them into Z-axis motor
on both sides. Attention, the side of the plug with 2 protuberances should upwards.
20. Find [X-axis motor cable] marked with [X-Steeper], insert it into X-axis motor. Attention: X-axis
motor cable socket is under the motor, the side of the plug with 2 protuberances should upwards.
18. Clip extruder wiring hardness into clips on
the filament fixed seats.
10
Advertisement
