Acom 700S User Manual page 12

PRECAUTIONS:
Both the mains voltage and the high DC voltage up to 500 V inside the ACOM 700S
amplifier are LETHAL!
For your safety, pull the amplifier power plug out of the mains wall outlet and WAIT AT
LEAST 3 minutes EACH TIME BEFORE you remove the cover of the amplifier.
Never allow anyone, ESPECIALLY CHILDREN, to push or put anything into holes in the
case - this will cause electric shock. NEVER TOUCH AN ANTENNA or antenna insulators
during transmission or tuning - this may result in an electric shock or burn. NEVER
EXPOSE the amplifier to rain, snow or any liquids. AVOID placing the amplifier in
excessively dusty environments or in direct sunlight. DO NOT OBSTRUCT COOLING ducts
or vents. Keep a minimum clearance distance of 10 cm (4 inches) to any other devices or
objects.
Do not undertake on your own repairs or changes in hardware or software of the
amplifier in order not to endanger your or other's health and life and not to damage the
amplifier and the equipment connected with it, not covered by warranty. The
manufacturer is not liable for another's actions and responsibility shall be assumed by
the doer.
To avoid damage (not covered under warranty) read the Section
User's Manual carefully. If you have any doubts about the installation, operation or
safety of the amplifier, please consult your dealer.
Page 12 of 52 | S e c t i o n GENERAL INFORMATION
User's Manual | ACOM 700S | 1.8-54 MHz Linear Amplifier
DANGER
DANGER
WARNING
WARNING
of this
2 INSTALLATION
May 2021