Canon imagePROGRAF GP-4000 Online Manual page 229

• • If the created custom paper does not appear as a candidate in the paper information list even if it is
fed many times, perform Paper feed adjustment again.
• • Errors may occur in the estimation results.
• Manage remaining roll amount
•
Selects the method to manage remaining roll amount and that to display warning when the roll is
running short.
◦ Barcodes
◦
Manages remaining roll amount by using a barcode.
By using the barcode every time you replace a roll, you can manage remaining roll amount properly.
Specify the roll length properly when you load a new roll.
◦ Auto estimate
◦
Estimates and manages the remaining amount of roll paper.
The estimated remaining roll amount is displayed on the HOME screen.
The barcode is not printed when Auto estimate is selected.
To estimate the remaining roll amount, Paper thickness and Paper core outer diameter have to
be set correctly.
When using a paper that is not listed in the paper information list, set Thickness and Paper Tube
Size in Advanced paper settings or in Media Configuration Tool.
For paper thickness and paper tube outer diameter size, contact the paper manufacturer.
Important
• If you do not select the media type correctly, the remaining roll amount may not be estimated •
correctly.
• • There is an error in the estimated remaining roll amount, and paper may run out during printing.
◦ Disable
◦
Select to disable managing remaining roll amount.
• Roll amount warning settings
•
Specifies when to warn the remaining roll paper amount.
Note
• This setting is enabled when Barcodes or Auto estimate is selected for Manage remaining roll
•
amount.
• Switch roll paper when low
•
Switches the roll paper for printing automatically when the roll is running out while printing is in progress.
◦ Enable
◦
This setting is valid only when Barcodes is selected for Manage remaining roll amount.
The roll paper for printing is switched with several rolls remaining.
229