Table of Contents
Advertisement
3. Install anchors at the marks and attach the mounting bracket to the wall.
4. Feed power and communication wires through the knockout in the bottom of the
mounting bracket.
5. Install the four screws attaching the metal back plate to the mounting bracket. Make sure
the two metal tabs are on top.
6. Plug in power connector and Ethernet cable (if using Ethernet) into the terminal. Also
connect signal wiring if applicable.
7. Slide the terminal onto the two tabs located at the top of the back plate. Secure
the reader to the back plate by inserting and tightening the screw located at the
bottom of the unit.
Your terminal is now mounted to the wall and ready to connect the power supply to the
outlet.
MTX-30P Push Installation & Operation Guide
Page 7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MTX-30P PUSH and is the answer not in the manual?