Creating Pppoe Wan Connection - D-Link DIR-822 User Manual

DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Router
User Manual

Creating PPPoE WAN Connection

On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 66. The page for creating a new PPPoE connection. The General Settings section.
Parameter
Interface
Connection name
Enable connection
NAT
Ping
RIP
General Settings
A physical or virtual WAN interface to which the new connection
will be assigned.
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Move the switch to the right to allow using RIP for this connection.
Page 78 of 213
Configuring via Web-based Interface
Description