DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Router
User Manual
Settings / Network
To configure the router's local interface, go to the Settings / Network page.
IPv4
Go to the IPv4 tab to change the IPv4 address of the router, configure the built-in DHCP server,
specify MAC address and IPv4 address pairs, or add own DNS records.
Figure 90. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter
Mode of local IP
address assignment
IP address
Mask
Gateway IP address
Local IP Address
Available if the Access point, Repeater, or Client mode was
selected in the Setup Wizard.
Select the needed value from the drop-down list.
Static: The IPv4 address, subnet mask, and the gateway IP
•
address are assigned manually.
Dynamic:
•
parameters from the LAN DHCP server or from the router to
which it connects.
The IPv4 address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Available if the Access point, Repeater, or Client mode was
selected in the Setup Wizard.
The gateway IPv4 address which is used by the router to connect to
the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Page 112 of 213
Configuring via Web-based Interface
Description
The
router
automatically
obtains
these