D-Link DIR-822 User Manual page 89

DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Router
User Manual
Parameter
Ping
RIP
RIPng
Figure 75. The page for creating a new PPPoE IPv6 connection. The Ethernet section.
Parameter
MAC address
MTU
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
For the PPPoE Dual Stack type only.
Move the switch to the right to allow using RIP for this connection.
Move the switch to the right to allow using RIPng for this
connection.
Ethernet
A MAC address assigned to the interface. This parameter is
mandatory if your ISP uses MAC address binding. In the field, enter
the MAC address registered by your ISP upon concluding the
agreement.
To set the MAC address of the network interface card (of the
computer that is being used to configure the router at the moment)
as the MAC address of the WAN interface, move the Clone MAC
address of your NIC switch to the right. When the switch is
moved to the right, the field is unavailable for editing.
To set the router's MAC address, click the RESTORE DEFAULT
MAC ADDRESS button (the button is available when the switch is
moved to the right).
The maximum size of units transmitted by the interface.
Page 89 of 213
Configuring via Web-based Interface
Description
Description