D-Link DIR-822 User Manual page 125

DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Router
User Manual
Parameter
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Destination port
Set source port
manually
Source port
Click the APPLY button.
To set a schedule for the IP filter rule, click the Set Schedule button (
corresponding to this rule. In the opened window, you can create a new schedule
section, page 194) or use the existing one. Existing schedules are displayed in the Interval of
execution drop-down list in the simplified mode.
To enable the IP filter rule at the time specified in the schedule and disable it at the other time,
select the Enable rule value from the Action drop-down list and click the SAVE button.
To disable the IP filter rule at the time specified in the schedule and enable it at the other time,
select the Disable rule value from the Action drop-down list and click the SAVE button.
To edit a rule, select the relevant line in the table. In the opened window, change the needed
parameters and click the APPLY button.
To change or delete the schedule for a rule, click the Edit schedule button (
corresponding to this rule. In the opened window, change the parameters and click the SAVE button
or click the DELETE FROM SCHEDULE button.
To remove a rule, select the checkbox located to the left of the relevant line of the table and click
the DELETE button (
The destination host end IPv4 or IPv6 address.
The destination subnet IPv4 or IPv6 address. The field is displayed
when the Subnet value is selected from the Set as drop-down list.
Ports
A port of the destination IP address. You can specify one port,
several ports separated by a comma, or a range of ports separated by
a colon.
Move the switch to the right to specify a port of the source IP
address manually. Upon that the Source port field is displayed.
A port of the source IP address. You can specify one port, several
ports separated by a comma, or a range of ports separated by a colon.
). Also you can remove a rule in the editing window.
Page 125 of 213
Configuring via Web-based Interface
Description
) in the line
(see the Schedule
) in the line