D-Link DIR-822 User Manual page 124

DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Router
User Manual
Parameter
Protocol
IP version
Direction
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Set as
Start IPv4 address /
Start IPv6 address
A protocol for network packet transmission. Select a value from the
drop-down list.
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
The direction of network packet transmission to which the rule will
be applied. Select the relevant value from the drop-down list.
LAN to WAN: The rule will be applied to the packets
•
transmitted from the local network to the external network.
WAN to LAN: The rule will be applied to the packets
•
transmitted from the external network to the local network.
LAN to Router: The rule will be applied to the packets
•
transmitted from the local network to DIR-822.
WAN to Router: The rule will be applied to the packets
•
transmitted from the external network to DIR-822.
Source IP Address
Select the needed value from the drop-down list.
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The source host end IPv4 or IPv6 address.
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Destination IP Address
Select the needed value from the drop-down list.
The destination host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
Page 124 of 213
Configuring via Web-based Interface
Description