Connecting To Web-Based Interface - D-Link DIR-822 User Manual

DIR-822 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh
Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
For security reasons, DIR-822 with default settings cannot connect to the Internet. To get
!
started, please set your own password used to access the web-based interface and, if
needed, configure other settings recommended by your ISP.
Start a web browser (see the Before You Begin section, page 18). In the address bar of the web
browser, enter the domain name of the router (by default, dlinkrouter.local) with a dot at
the end and press the Enter key. Also you can enter the IP address of the device (by default,
192.168.0.1).
Figure 22. Connecting to the web-based interface of the DIR-822 device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Setup Wizard opens (see the Setup Wizard section, page 45).
Figure 23. The page for running the Setup Wizard.
Page 37 of 213
Installation and Connection