Friction Brake - Volvo Penta V8-350 Operator's Manual

Instruments and Controls
P0008707
P0008706
24

Friction Brake

Volvo Penta controls have a friction brake that can be
adjusted to provide lighter or heavier lever action. If
your control is too hard or too easy to move, follow the
instructions below to make the adjustment.
NOTICE! Only adjust the brake when the control lever
is in the throttle range. Do not adjust the friction with
the control in neutral.
Top Mount Remote Controls
1 Make sure the engine is turned off by removing the
key from the ignition switch.
2 Remove the plastic cover that shields the remote
control mechanism.
3 For single lever controls, move the throttle to the
forward position. For dual lever controls, move the
port side lever forward and the starboard side lever
into reverse.
4 Turn the tension screw A clockwise to increase
drag and counter-clockwise to decrease drag on
the control arm.
5 Reinstall the plastic cover and remote control lever.
Side Mount Remote Controls
1 Make sure the engine is turned off by removing the
key from the ignition switch.
2 Remove the plastic cover that shields the remote
control mechanism.
3 Place the control lever in reverse (just beyond the
reverse detente position) and adjust the throttle
brake screw to prevent throttle creep.
4 Turn the tension screw B clockwise to increase
drag and counter-clockwise to decrease drag on
the control arm.
5 Reinstall the plastic cover and remote control lever.
Other control manufacturers may have a different
method for adjusting the friction brake. Check with your
dealer or the control manufacturer for the adjustment
procedure.
47707742 09-2016 © AB VOLVO PENTA