Table of Contents
Advertisement
ANT130R Hardware Manual
Chapter 2: Mechanical Specifications and Installation
WARN IN G: The ANT130R must be installed according to the instructions in this manual
and any accompanying documentation. Failure to follow these instructions could result in
injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
WARN IN G: Manually lifting and moving the stage requires a minimum of two people on
either side of the stage. Refer to
Do not attempt to lift heavy loads single handed.
l
Follow the lifting instructions and only manually lift from the specified surfaces (if
l
lifting hardware hasn't been supplied).
Do not use any of the cables as lifting points.
l
WARN IN G: It is the customer's responsibility to safely and carefully lift the stage.
Make sure that all moving parts are secure before moving the ANT130R. Unsecured
l
moving parts may shift and cause bodily injury.
Improper handling could adversely affect the performance of the ANT130R. Use
l
care when moving the ANT130R.
IM PORTAN T: If any damage has occurred during shipping, report it immediately.
Carefully remove the ANT130R from its protective shipping container. Gently set the ANT130R on a
smooth, flat, and clean surface.
Before operating the ANT130R, it is important to let it stabilize at room temperature for at least 12
hours. Allowing it to stabilize to room temperature will ensure that all of the alignments, preloads, and
tolerances are the same as they were when tested at Aerotech. Use compressed nitrogen or clean, dry,
oil-free air to remove any dust or debris that has collected during shipping.
Each ANT130R has a label listing the system part number and serial number. These numbers contain
information necessary for maintaining or updating system hardware and software. Locate this label and
record the information for later reference.
www.aer otech.com
Mechanical Specifications and Installation
Section 1.3.
for stage mass specifications.
Chapter 2
13
Advertisement
Table of Contents
