Table of Contents
Advertisement
Available languages
Available languages
3. ANGLE GUIDE
The angle guide will help create a consistent bevel across the entire edge of a blade.
The guide can be set to 20° or 25°. The guide can be removed completely for belt
changes or grinding tasks.
To install, align and slide the guide
over the fasteners. Push until the
guide snaps into place.
To remove, pull up on the guide.
NOTE: The belt tracking screw
(accessible with the guide removed)
Back side of sharpener shown
can be adjusted to correct belt
for reference
tracking.
SNAP
SNAP
Adjust the angle by pushing the
lever on the back of the guide up
or down. The lever will snap into
position.
SNAP
SNAP
Down for 25°
Up for 20°
1 4
|
S E T T I N G U P Y O U R S H A R P E N E R
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the WSKTS2-I and is the answer not in the manual?
Questions and answers