Technical Data; Electrical Data; Burner Equipment - Riello RG2 Installation, Use And Maintenance Instructions

4.3

Technical data

Model
Delivery
(1)
Thermal power
(1)
Fuel
Operation
Use
Ambient temperature
Combustion air temperature
Pump
Noise levels Sound pressure
(2)
Sound power
Burner weight
Reference conditions: Ambient temperature 20°C - Barometric pressure 1013 mbar -Altitude 0m a.s.l. (H i = 11.86 kWh/kg)
(1)
Sound pressure measured in manufacturer's combustion laboratory, with burner operating on test boiler and at maximum output. The sound power
(2)
is measured with the "Free Field" method, as per EN 15036, and according to an accurate "Accuracy: Category 3" measurement, as described in
EN ISO 3746.
4.4

Electrical data

Model
Power supply
Motor
Capacitor
Ignition transformer
Absorbed electrical power
Protection level
4.5

Burner equipment

RG2 - RG3 burners
Flange with insulating gasket .............................................. No. 1
Screw and nuts for flange ................................................... No. 1
Remote reset connection .................................................... No. 1
Screws and nuts for fixing the flange to the boiler .............. No. 4
Flexible hoses with nipples ................................................. No. 2
Installer booklet ................................................................... No. 1
Spare Parts List................................................................... No. 1
Remote reset kit
The burner has a remote reset kit (RS) consisting of a connection
and a push-button operating at a distance of 20 metres max.
In order to install it, remove the safety lockout device installed at
the factory and insert the lockout supplied with the burner (see
electrical diagram).
20136866
Technical description of the burner
RG2
4 10
kg/h
47 119
kW
°C
°C max
bar
61
dB (A)
72
kg 13
RG2
Single-phase, ~50Hz
230V ± 10%
A 0.9
rpm 2750
rad/s 289
F
4
kW 0.18
8
RG3
7 15
83 178

Light oil, viscosity 4
Intermittent (FS1)
Boilers: water and diathermic oil
0 - 40
40
Pressure: 8
64
75
15
RG3 RG1F TL
Single phase, ~ 50-60Hz
1.8 0.9
2800 2750
294 289
6.3 4
Secondary 18 kV - 25 mA
0.39 0.155
(50Hz)
IP 40
RG1F TL - RG2F TL burners
Flange with insulating gasket .............................................. No. 1
Screw and nuts for flange.................................................... No. 1
Screws and nuts for fixing the flange to the boiler............... No. 4
7 pin plug............................................................................. No. 1
Flexible hoses with nipples.................................................. No. 2
Installer booklet ................................................................... No. 1
Spare Parts List................................................................... No. 1
GB
RG1F TL RG2F TL
2.7 5 4 10
32 60 47 119
2
6 mm /s at 20°C

15
60
71
13
RG2F TL
220/230V ± 10%
0.9 0.9
3300 2750
347 289
4
0.200 0.165
(60Hz) (50Hz)
61
72
13
Tab. B
1
3135
329
0.220
(60Hz)
Tab. C