Lowering The Hopper Without Power; Transporting The Machine - Toro MB TX 2500 Operator's Manual

Lowering the Hopper
without Power
1. Install the cylinder lock; refer to
Cylinder Lock (page
2. Ensure that the tub is empty.
3. Place a large drain pan under the
hydraulic-manifold block
Figure 12
1. Hydraulic-manifold block
4. Disconnect the hose fittings in the manifold
block and allow the fluid to drain into the pain.
Note:
Dispose of the used fluid at a certified
recycling center.
5. Connect the hose fittings.
6. Use a hoist or have 2 people hold up the hopper
and remove the cylinder lock.
7. Carefully lower the hopper to the machine frame.
Installing the
18).
(Figure 12).

Transporting the Machine

Use a heavy-duty trailer or truck with full-width ramps
to transport the machine. Ensure that the trailer or
truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you, your family, pets or bystanders avoid injury.
Refer to your local ordinances for trailer and tie-down
requirements.
Important:
Do not operate or drive the machine
on roadways.
1. Lower the hopper.
2. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
3. If applicable, connect the trailer brakes.
4. Carefully load the machine onto the trailer or
g186548
truck.
5. Shut off the engine, remove the key, and set
the brake.
6. Use the metal tie-down loops on the machine to
securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes
1. Front tie-down loops
15
(Figure
Figure 13
2. Rear tie-down loops
13).
g185890