Checking The Hydraulic Lines - Toro MB TX 2500 Operator's Manual

Replacing the Hydraulic Filter for
the Lift System
Service Interval: Every 300 hours
Important:
Do not substitute an automotive oil
filter or severe hydraulic system damage may
result.
1. Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, raise the
hopper, and install the cylinder lock.
2. Shut off the engine, and remove the key. Allow
the engine to cool.
3. Replace the filter as shown in
Figure 51
4. Start the engine and let it run for about 2 minutes
to purge air from the system.
5.
6.
7.
-
EUTRAL LOCK
Checking the Hydraulic
Lines
Service Interval: Every 40 hours—Check the
Figure 51.
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
g186042 within a few hours by a doctor familiar with
this form of injury; otherwise, gangrene may
result.
• Keep your body and hands away from
• Use cardboard or paper to find hydraulic
g027477
36
Shut off the engine and check for leaks.
Check the fluid level in the reservoir tank, refer
to Checking the Hydraulic-Fluid Level for the Lift
System (page 34).
Note:
Do not overfill the reservoir tank.
Remove the cylinder lock and lower the hopper.
hydraulic lines for leaks, loose
fittings, kinked lines, loose mounting
supports, wear, and deterioration.
(Make necessary repairs before
operating.)
WARNING
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
leaks; never use your hands.