Changing The Engine Oil And Filter - Toro MB TX 2500 Operator's Manual

Changing the Engine Oil
and Filter
Service Interval: Every 100 hours
Oil Type:: Detergent oil (API service SJ or higher)
Engine Oil Capacity: 1.9 L (64 fl oz)
Viscosity: Refer to the table below.
Figure 21
Change the engine oil while the engine is warm.
Note:
Dispose of the used oil at a recycling center.
1. Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, raise the
hopper, and install the cylinder lock.
2. Shut off the engine and remove the key.
3. Perform the following steps to change the
engine oil:
A. Remove the drain plug and allow all of the
existing oil to drain out of the engine
22).
g017552
4.
-
EUTRAL LOCK
(Figure
21
Figure 22
B. Install the drain plug
plug to 13.6 N∙m (10 ft-lb).
Change the engine-oil filter as shown in
23.
g185888
g031623
(Figure 22). Torque the
Figure