Toro MB TX 2500 Operator's Manual page 27

Figure 31
1. Positive battery cable
2. Securing rod
4. Remove the positive battery cable from the
battery (Figure 31).
5. Remove the 2 wing nuts, securing rod, and the
battery (Figure 31).
Installing the Battery
1. Place the battery on the platform and secure
it using the 2 wing nuts and the securing rod
(Figure 31).
2. Install the positive battery cable to the battery
(Figure 31).
3. Install the negative battery cable to the battery
(Figure 31).
g185906
3. Wing nut (2)
4. Negative battery cable
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity) to prevent battery damage
when the temperature is below 0°C (32°F).
1. Remove the battery from the chassis; refer to
Removing the Battery (page
2. Perform the following steps to check the
electrolyte level:
A. Ensure that the cell covers are free from dirt
and debris.
Important:
the battery cells causes damage to the
battery.
B. Remove the covers from the top of the cells.
C. Ensure that the electrolyte solution covers
the lead plates. Use distilled water to top off
the solution level, if needed.
3. Ensure that the filler caps are installed on the
battery.
4. Charge the battery for 1 hour at 25 to 30 A or 6
hours at 4 to 6 A.
5. When the battery is fully charged, unplug the
charger from the electrical outlet, and disconnect
the charger leads from the battery posts
32).
6. Install the battery onto the machine and connect
the battery cables; refer to
(page 26).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
1. Positive battery post
2. Negative battery post
26
25).
Dirt and debris that enters
Installing the Battery
Figure 32
3. Red (+) charger lead
4. Black (-) charger lead
(Figure
g000538