Download Print this page
HWAM 4620 User Manual
Hide thumbs Also See for 4620:

Advertisement

Quick Links

User's Manual
EN
4620
4640
4660
01.11.2020 / 97-9684
www.hwam.com
AUTOPILOT

Advertisement

loading
Need help?

Need help?

Do you have a question about the 4620 and is the answer not in the manual?

Questions and answers

Summary of Contents for HWAM 4620

  • Page 1 User's Manual 4620 4640 4660 01.11.2020 / 97-9684 www.hwam.com AUTOPILOT...
  • Page 2: Table Of Contents

    Table of contents Drawings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation .
  • Page 3: Drawings

    Page 3 of 20 pages...
  • Page 4 Page 4 of 20 pages...
  • Page 5 Page 5 of 20 pages...
  • Page 6 Page 6 of 20 pages...
  • Page 7 Page 7 of 20 pages...
  • Page 8 Page 8 of 20 pages...
  • Page 9: Installation

    In general Congratulations on your new HWAM woodburning stove. We are pleased that you have chosen a HWAM woodburning stove and confident that it will give you much pleasure. To ensure optimum operation and safety, we recommend that the installation should be carried out by an authorised HWAM retailer or a fitter recommended by the retailer.
  • Page 10 European, national and local regulations must be observed in terms of the size and thickness of a non- combustible floor covering the floor in front of the combustion chamber opening. Ask your HWAM retailer for assistance. The combustion chamber opening is 45,0 cm wide.
  • Page 11 The chimney and flue duct must be of flue class T400 and be CE marked. Furthermore, it must have obtained the classification of G in soot fire testing. The required distance to combustible material must be complied with in accordance with the brand label. Ask your HWAM retailer for further information.
  • Page 12 4. Back flue outlet. Closed at the factory using a plate affixed with screws. The flue outlet is thus concealed behind the rear plate. 5. Removable rear plate which conceals the HWAM Autopilot™. Must always be installed if the stove ®...
  • Page 13: Firing Manual - Wood

    IrIng manual wood Your first heating session The lacquer will be fully hardened after the stove has been used, and the door and the ashpan should be opened very carefully as there will otherwise be a risk that the gaskets will stick to the lacquer. In addi- tion the lacquer may initially give off an unpleasant odour, so make sure that the room is well ventilated.
  • Page 14 The stove can then be stoked again. Important! The ash pan must not be opened during the lighting stage and must always be kept closed when the stove is lit or the HWAM Autopilot™ might be damaged. Only open the door when lighting ®...
  • Page 15: Firing In General

    make the stove burn slower. Turning to maximum (clockwise) will increase the rate of combustion and make the stove burn faster. Wait until the layer of embers is suitably low before stoking again. During combustion, the outer surfaces of the stove will become hot, and due care must therefore be shown.
  • Page 16: Maintenance

    All service checks must be performed by an authorised fitter. Use only original spare parts. Inside cleaning Before chimney sweeping can be performed, the air control knob must be set to its minimum position to prevent soot and ash from entering the HWAM Autopilot™. Unless the safety fittings for transportation ®...
  • Page 17 However, it should be replaced, if there are actual holes due to parts of the lining falling off or when, due to wear and tear, it has been reduced to less than half its original thickness. HWAM Autopilot™ (Drawing G) ®...
  • Page 18: Operational Problems

    Stop using the stove and contact the retailer. At interruptions that you cannot yourself rectify, you should contact the retailer. eclaratIon oF erFormance The DoP can be downloaded from our website via the following links: www.hwam.com/dop/4600 Page 18 of 20 pages...
  • Page 19: Product Informaiton Ecodesign

    • Always dispose of items in a way that is as sustainable as possible and that is in line with the current environmental protection, reprocessing/recycling and disposal technology HWAM A/S • Nydamsvej 53 • DK-8362 Hørning Page 19 of 20 pages...
  • Page 20 www . h wam . c om...

This manual is also suitable for:

46404660