Lubrication And Filling Points Of The Front Driving Axle; Oil Filling, Inspection And Drain Holes Of Front Wheel Reducers; Refilling Of Brake Fluid - Zetor PROXIMA PLUS 2011 Series Operator's Manual

LUBRICATION AND FILLING POINTS
OF THE FRONT DRIVING AXLE
1 - Steering knuckle lubricator.
2 - Sliding bearing (2x) of the front driv-
ing axle.
3 - Gearbox oil drain hole.
4 - Oil filling and inspection hole on the
gearbox (after screwing off the in-
spection screw the oil level shall
reach the lower edge of the inspec-
tion hole).
MAINTENANCE INSTRUCTIONS
E733
OIL FILLING, INSPECTION AND
DRAIN HOLES OF FRONT WHEEL
REDUCERS
Carry out check, filling and draining of oil
through one hole after turning the re-
ducer as illustrated.
1. Check of oil level – the hole is in the
reducer horizontal axis (after screw-
ing off the inspection screw the oil
level shall reach the lower edge of
the inspection hole).
2. Filling of oil – the hole is on the top.
3. Drainage of oil from a non-braked
axle – the hole is in the bottom.
4. Drainage of oil from a braked axle –
the hole is in the bottom.
160
G731

REFILLING OF BRAKE FLUID

The tank is located on the left side of the
tractor in front of the cabin and accessi-
ble after lifting of the bonnet.
Keep level of brake fluid within 3/4 (max.
height) and 1/2 (min. level) of the tank
volume.
When manipulating with brake
fluid observe strict cleanness.
Check level every day before you
drive out.
G735a