Vdc Model (See Figure 3); Wiring To The Controller Board; Figure 3 I-Ip15-024 Pc Boards - Federal Signal Corporation Informer15 Description, Specifications, Installation, Operation, And Service Manual

Installation

24 Vdc model (See Figure 3)

To wire the 24 Vdc model:
1.
2.

Figure 3 I-IP15-024 PC Boards

24 Vdc Power Input Board
To Amplifier
Board
JP2
JP1
Amplifier Board
To 24 Vdc Power Input Board

Wiring to the Controller Board

To wire the Controller Board:
1.
2.
16
Connect the Ethernet field wiring to M1 on the Controller board.
Connect the 24 Vdc power input to the JP2 on the 24 Vdc Power Input board. An
additional 24 Vdc Informer15 speaker can be connected to JP3 if required.
JP3
1
External Inputs
2
dry contact
3
closures
4
Use JP13 to provide tone and messages into the Informer15 via the microSD memory
card.
If local activations are required, use JP2.
The Alarm Initiation Inputs are activated by shorting the input to the ISO-GND next to
it, usually through a normally open switch or normally open dry relay contact.
NOTE: Momentary mode: contact closure sounds the alarm for the typical
programmed duration. Continuous mode: sounds alarm for the duration of the
closure. The system can also be configured to allow activation from normally closed
contacts.
JP2 – Alarm Initiation Inputs
1 – ISO-GND
2 – Input #1
3 – ISO-GND
4 – Input #2
Controller Board
M1
JP9 JP5
JP4
JP8
JP2
Serial Port
Lamp
Test
JP3
JP11
JP1
Visual Indicator
Informer15 Speaker (Model I-IP15X Series C)
To Local Area
Network
LAN
Interface
JP13
Removable
MicroSD card
JP6
External Relay
Federal Signal www.fedsig.com