Installing Lights On The Siren; Installing The Top Light Kit; Figure 8 Top Light; Table 14 Top Light Kit (Model 191Xl-024R) - Federal Signal Corporation Modulator MOD Series Description, Specifications, Installation, And Service Manual

Installing Lights on the Siren

Modulator models can be ordered with optional top lights and/or side lights. If not
ordered with the Modulator siren, they can be added later by purchasing the Top Light Kit
(Federal Signal part number 191XL-024R) or Side Light Kit (Federal Signal part number
MOD-QF-KIT). Modulator models purchased after September 2017 are preconfigured to
support Top Light and Side Light Kits.
NOTE: The standard light referenced is the color red, but other colors are available.
The following instructions refer to the configuration of the Modulators that have been
preconfigured.

Installing the Top Light Kit

The Top Light Kit is installed onto the strobe bracket that extends out of the top module.
To install the Top Light Kit:
1. Remove the strobe bracket cap.
2. Locate the two spare wires within the strobe bracket.
3. Connect the top light wiring to the two spare wires (red/white positive and red/black
negative) from the wire harness within the module.

Figure 8 Top Light

Table 14 Top Light Kit (Model 191XL-024R)

Item No.
200
Description, Specifications, Installation, and Service Manual
Qty. Description
1 Light, HAZ, LOC, LED, Red
Part Number
191XL-024R
Installation
21