Table 3 Hazardous Location Ratings; Table 4 Connectors And Jacks For The Controller Board; Table 5 Connectors And Jacks For The Amplifier Board - Federal Signal Corporation Informer15 Description, Specifications, Installation, Operation, And Service Manual

Table 3 Hazardous Location Ratings

CLASS I, DIV 2, GRPS A,B,C,D T2B
CLASS II, DIV 2, GRPS F,G
CLASS III

Table 4 Connectors and Jacks for the Controller Board

JP1
JP2
JP3
JP4
JP5
JP6
JP8
JP9
JP11
JP12
JP13
M1

Table 5 Connectors and Jacks for the Amplifier Board

JP1
JP2
JP3
JP4
Pin1
Pin2
VR1
Description, Specifications, Installation, Operation, and Service Manual
Federal Signal www.fedsig.com
T-CODE AT 65°C
LED Lamp Test
Short pins 1 and 2 to turn on LED lamp
Inputs
1 – ISO-GND
2 – Input #1
3 – ISO-GND
4 – Input #2
5 – ISO-GND
6 – Input #3
7 – ISO-GND
8 – Input #4
LED Lamp Output
1 – GND
2 – Power, switched +24 Vdc
Test mode
Factory Default
Short pins 1 and 2 to restore to factory defaults
Open Collector Output
1 – Output #1 Open Collector Output
2 – Output #1 +24 Vdc
Option1 Jumper
Short pins 1 and 2 for Standalone Option
Option2 Jumper
Short pins 1 and 2 for Option
Serial Port RJ25 6 conductor mod jack
Controller to Amplifier Interface
microSD FLASH card holder
Communications from PoE board
Power Input from PoE board or the 24 Vdc power board
Balanced Audio Input – 10 or 25 V
Audio Input Select Jumper (Not used with I-IP15 configuration.)
Jumper 1 and 2 = 25 V
Jumper 3 and 4 = 10 V
Amplifier to Controller Interface
(-) Speaker output
(+) Speaker output
Amplifier Gain (For max volume, turn clockwise.)
Constant on 5 min Duty Cycle
T3A
T6 T6
T6 T6
RMS
input
RMS
input
RMS
Specifications
in (Not used)
11