Installation
Flat Surface Mounting
The speaker can be mounted on any relatively flat surface. Conduit connections can be
made to the two 1/2-inch threaded openings at the bottom of the housing. A 1/2-inch
conduit plug is supplied for field installation if one of the 1/2-inch threaded openings is
not used. After the mounting location and mounting method have been selected, proceed
with the applicable instructions below.
To flat surface mount the Informer15 Speaker:
1.
2.
DRILLING PRECAUTION: Before drilling holes in any surface, ensure that both
sides of surface are clear of items that could be damaged.
3.
4.
5. Reposition speaker projector if necessary to obtain desired sound coverage. Loosen
Figure 1 Depth and Height of Informer15 Speaker
13.9" [353 mm ]
1.12" [28 mm ]
14
Select the mounting location and place the rear of the housing against the mounting
surface.
Use the four mounting holes on the external housing bracket as a template to scribe
drill position marks on the mounting surface. See Figure 1 for mounting hole locations
and dimensions.
Secure the unit to a wooden mounting surface with #10 x 1-inch wood screws. If
mounting on a metal surface, drill 13/64-inch diameter holes and secure the unit with
#10 screws, lock washers, and nuts.
Route wires through the 1/2-inch threaded openings into the Informer15 Speaker unit
per National and Local Electrical codes.
the collar nut and move the projector to the desired position. See Figure 1.
10.0" [253 mm ]
8.6" [219 mm ]
3.38" [86 mm ]
10.2" [258 mm ]
1.00" [25 mm ]
2.30" [58 mm ]
2.00" [51 mm ]
5.50" [140 mm ]
6.00" [152 mm ]
Informer15 Speaker (Model I-IP15X Series C)
Federal Signal www.fedsig.com
1.50" [38 mm ]
Ø0.20" [Ø5 mm ]
MOUNTING HOLES
(4 PLCS.)
CONDUIT
ENTRANCE
1/2"-14" NPT
(2 PLCS.)