Table of Contents
Advertisement
KNX – DALI
TM
Intesis
After scan is done, total number of found devices will be shown in 'DALI Network:' label. Note that type column will
fill only if device has a short address assigned, if not, type cannot be read.
Next step is associating a short address between 0 to 63 to each found ballast. To do so, following options are
possible:
1. Identify the device in the installation with the Wink button, and then double click in short address field of
the device in DALI Network window, and assign it an address 0..63.
2. Use the Auto Addr. Button to automatically assign a correlative address to each ballast.
Address of each ballast can be deleted at any time, using button Delete Addr. Multiple selection is possible (using
Shift and Control keys together with mouse-clicks).
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
5CB6A9
A.9
Figure
Example of scan results
User Manual r1.0 EN
B9F4AF
URL
https://www.intesis.com
39 / 41
Advertisement
Table of Contents
Need help?
Do you have a question about the Intesis INKNXDAL0640200 and is the answer not in the manual?
Questions and answers