Gaggia Milano MAGENTA MILK Operating Instructions Manual page 31

Problem
The milk does not froth. The Capp in Cup system is dirty
The "INTENZA+" filter
cannot be inserted.
You can not activate the
"INTENZA+" filter.
There is some water
under the machine.
The machine is in
DEMO mode.
4219-465-02541 MAN. GAG. MAGENTA Milk EN-NL-PL Rev 02.indd 31
Cause
or not correctly inserted. Or, the
system has not been correctly
installed in all its components.
The type of milk used is not
suitable for foaming.
Remove the air from the filter.
The tank still contains some water.
The rubber seal is not inserted onto
the "INTENZA+" filter.
Another filter is already active
The drip tray is too full and has
spilled over.
While switching on the machine,
you pressed a combination of
buttons (HOME - CLEAN/SET
– HOME - CLEAN/SET
HOME
).
HOME
clean/setting
clean/setting
Solution
Clean the Capp in Cup system as indicated
in the chapter "Capp in Cup System Deep
Cleaning Under Running Water", then place it
back in the right way.
Make sure all components have been correctly
assembled.
The amount and the quality of froth vary
depending on the type of milk.
Let the air bubbles out of the filter.
Empty the water tank before installing the filter.
Check the packaging and insert the seal onto
the "INTENZA+" filter.
The machine indicates the filter usage in
percentage.
However, if you want to activate a new filter
before the one currently in use has expired, the
latter must be disabled first and as described
in section "Replacing INTENZA+ water filter"
Empty the drip tray when the mark appears
though the tray. Always empty the drip tray
before starting the descaling procedure.
Switch the machine off and on again, with the
ON/OFF button on the control panel.
ON/OFF
English
31
09/09/2020 16:48:15