State Information - Warning Signals - Unitek BAMOCAR-PG-D3-700/400 Manual

State displays
5.3

State information - warning signals

The state "warning" is signalled by the flashing red fault LED and the green seven-segment display
indicates alternately the state and the warning no.
Display Error
Servo: NDrive:
0 WARNING_0
1 ILLEGAL STATUS
2 SAFE_IN
3
4
5
6 MOTORTEMP
7 DEVICETEMP
8 Vout_Sat
9 I_PEAK
A RACEWAY
B
C
D
E
F BALLAST
Note:

Warning F is a device-dependent warning (for BAMOBIL and BAMOCAR without function)
Example: Warning no. 7
Light display:


Edition: 2020 / V4
Description:
No device identification
RUN signal disturbed, EMI
RFE input inactive (active without RUN input)
Motor temperature > (I-red-TM or 93 % from
Device temperature > 87 % of limit
Limit of the existing voltage output is reached
Overcurrent 200 %
Resolution range of the speed measurement exceeded
Ballast circuit > 87 % overloaded
FAULT LED red - flashing
The display swaps between the state
and the warning no. 7
Page: 48
Address:
RegID 0x8F
Bit 16
Bit 17
Bit 18
Bit 19
Bit 20
Bit 21
Bit 22
M-Temp)
Bit 23
Bit 24
Bit 25
Bit 26
Bit 27
Bit 28
Bit 29
Bit 30
Bit 31
DEVICETEMP
Motor temperature
(I-red-TM or 93 % of M-Temp)
BAMOCAR-PG-D3-700/400-400
H