Mitsubishi Electric 800 Series Instruction Manual page 55

• Phoenix Contact Co., Ltd.
Wire gauge
2
(mm )
With insulation sleeve
0.3 AI 0,34-10TQ
0.5 AI 0,5-10WH
0.75 AI 0,75-10GY
1 AI 1-10RD
1.25, 1.5 AI 1, 5-10BK
0.75 (two-wire
AI-TWIN 2×0,75-10GY
product)
• NICHIFU Co., Ltd.
Wire gauge
2
(mm )
0.3 to 0.75
3.
Insert the wire into the terminal block.
NOTE
• When using stranded wires without a blade terminal, twist enough to avoid short circuit with a nearby terminals or wires.
• Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause an inverter damage
or injury.
 Wire removal
Pull the wire while pushing the open/close button all the way down firmly with a flathead screwdriver.
54
2. Installation and Wiring
2.6 Control circuit
Ferrule part No.
Without insulation
sleeve
—
—
A 0,75-10
A 1-10
A 1, 5-10
—
Blade terminal part
Insulation cap part No.
No.
BT 0.75-11 VC 0.75
Open/close button
Flathead screwdriver
Crimping tool
model No.
CRIMPFOX 6
Crimping tool model
No.
NH 69
When using single wire or stranded wire without crimp terminal,
push an open/close button all the way down with a flathead
screw driver, and insert the wire.
Open/close button
Flathead screwdriver