Installing The Wall Mount; About Ceiling-Mounted Cameras; Cabling Notes - VADDIO ConferenceSHOT AV Installation Manual

Installation Guide for ConferenceSHOT AV Enterprise-Class Conferencing System

Installing the Wall Mount

The camera is shipped with a wall mount. Other mounting options are available as well. Contact us if you
don't have the camera mount you need.
You can install the camera wall mount to a 2-gang wall box or directly to the drywall.
If you mount it to drywall, use the wall anchors provided with the wall mount.
n
If you mount it to a wall box, use the cover plate screws supplied with the wall box.
n
If you install the camera wall mount to drywall, use the wall anchors provided with the mount.
This mount may be installed as shown, or flipped 180° so that the wall attachment is directly behind the
camera.

About Ceiling-Mounted Cameras

If you use an inverted mount, set the camera's Image Flip mode ON for inverted operation. This orients the
video image correctly and sets the tilt motors to respond appropriately to tilt up and down commands from
the remote, web interface, and connected control devices. This control is available to the administrator on
the web interface's System page.

Cabling Notes

Caution
When building cables for Vaddio products, do not use pass-through RJ-45 connectors. If they
are crimped incorrectly, they can cause intermittent connections and degrade signal quality.
Incorrectly crimped pass-through connectors can also damage the connectors on the product,
which will void your warranty.
Intact – will make reliable contact
with cable connector
Damaged – Bent contact fingers
will NOT make reliable contact
with cable connector
12