Replacing The Fans - Kaco Blueplanet 87.0 TL3 Series Manual

↻ Cleaning the heat sink requires the fan to be removed.
↻ Switch off the device and secure it against restart.
↻ Keep a suitable brush ready for cleaning.
1 Remove the hood and fan Replacing the fans [See section 11.3} Page 92].
2 Clean the free space between the cover and the heat sink using suitable
brushes.
3 Clean the heat sink with a suitable brush.
NOTE: Do not use any aggressive cleaning agents and ensure that no other
components come into contact with fluids.
» Cleaning completed – if necessary, remount the fans.
11.3

Replacing the fans

Removing the cover
↻ A check has been performed to ensure there is no AC/DC voltage present.
1 Remove the fastening screws on the cover from both sides [ _T20]
2 Lift up the cover from both sides and press it out of the mounting clips.
3 Set the cover to one side.
» Proceed with the cleaning or removal of the fans.
Page 92 KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
3x
2 mm
2
Fig. 102: Cleaning the cooling fins
from above
4x
2
1
Fig. 103: Cleaning the cooling fins
from below
1 Heat sinks / space between
heat sinks
2 Brush (max. wire diameter
2mm)
4
3
2
Fig. 104: Removing the cover
1 Cover
2 Fastening screw
3 Mounting clips
4 Fans
KACO blueplanet 137 TL3 KACO blueplanet 150 TL3
1
1