Fluid Needles - DeVilbiss ADVANCE HD Series Manual

Parts Replacement/Maintenance
Chart 1 – Air Caps
PART No. FOR SUCTION OR
AIR CAP PRESSURE
SP-100-430-K SUC & PRESS
SP-100-443-K SUC & PRESS
SP-100-497-K PRESSURE
SP-100-470-K PRESSURE
NOTE: When removing air cap from retaining ring, don't remove the Slip Ring (2) or Retaining Ring Seal (5) from
the Retaining Ring. Damage to the parts may occur. Slip ring and Retaining Ring seal are not available as
replacements. Simply wipe parts clean and reassemble with new or clean air cap.
Chart 2 – Fluid Nozzle Range & Fluid Needle
Chart 3 – Optional Fluid Nozzles & Fluid Needles
PART No. ON FLUID NOZZLE
SP-200N-14-K
SP-200N-18-K
SP-200N-22-K
SP-200S-10-K
SP-200S-12-K
SP-200S-14-K
SP-247N-22-K
SP-247N-28-K
SP-247C-22-K
SP-247C-28-K
NOTE: When replacing the fluid nozzle or fluid needle, replace both at the same time. Torque to 9–11 Nm (80–100
ft-ins). Don't over tighten the fluid nozzle. Use SN-28 10mm Spanner supplied with the gun and check with a torque
wrench.
TECHNLOGY
CONVENTIONAL
CONVENTIONAL
CONVENTIONAL
CONVENTIONAL
PART No. ON FLUID NOZZLE
SP-200S-085-K
SP-200S-10-K
SP-200S-12-K
SP-200S-13-K
SP-200S-14-K
SP-200S-16-K
SP-200S-18-K
SP-200S-20-K
SP-200S-22-K
SP-247S-22-K
SP-247S-28-K
PART No. NEEDLE
ADV-310N-14-K
ADV-310N-18-K
ADV-310N-22-K
ADV-310P-10-K
ADV-310P-12-K
ADV-310P-14-K
ADV-310N-22-K
ADV-310N-28-K
ADV-310C-22-K
ADV-310C-28-K
MARKING ON RECOMMENDED INLET
AIR CAP
430
443
497
470
PART No. NEEDLE
ADV-310-085-K
ADV-310-10-K
ADV-310-12-K
ADV-310-13-K
ADV-310-14-K
ADV-310-16-K
ADV-310-18-K
ADV-310-20-K
ADV-310-22-K
ADV-310-22-K
ADV-310-28-K
MATERIAL
HARDENED
HARDENED
HARDENED
PLASTIC TIPPED
PLASTIC TIPPED
PLASTIC TIPPED
HARDENED
HARDENED
CARBIDE
CARBIDE
14
PRESSURE
(bar)
3.0
3.0
3.0
3.0
FOR AIRCAPS
430
443
497
470
FOR AIRCAPS
430
443
497
470
© 2012 Finishing Brands UK Ltd.
AIR FLOW
(L/min) @ 3
bar
290
325
500
460