Installing The Grill Cooking Components; Installing Grease Bucket; Connecting To A Power Source - Pit Boss NAVIGATOR PB850G Assembly Manual

15. INSTALLING THE GRILL COOKING COMPONENTS

Parts Required:
1 x Cooking Grid A (#27)
2 x Cooking Grid B (#28)
Porcelain-Coated Steel Upper Warming Rack (#29)
1 x
Installation:
• Place the Cooking Grids, side by side, on the grid ledge inside the Main Grill.
• Place the Upper Cooking Rack on the upper ledge inside the Main Grill.
The Warming Rack will lock into place.
16. INSTALLING THE GREASE BUCKET
Parts Required:
Grease Bucket (#25)
1 x
Installation:
• Place the Grease Bucket on the spout hook on the end of the Main Barrel.
Ensure it is level to avoid grease spills.
• The unit is now completely assembled.

17. CONNECTING TO A POWER SOURCE

NOTE: Before plugging your Pit Boss
the temperature dial is in the OFF position.
STANDARD OUTLET
•
This appliance requires 220-240 volts, 50hz, 250w service. It must be a
3-prong grounded plug.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity, which
can be too much power for a GFCI outlet to handle. Each time it trips, it
increases in sensitivity. If the GFCI keeps tripping, replace the outlet or
change to a non-GFCI outlet.
IMPORTANT: Disconnect unit from power source when not in use.
IMPORTANT: Refer to Owner's Manual for Operating Instructions
10
into any electrical outlet, ensure
®
15
29
28
27
28
16
17
FAST-BLOW FUSE,
5 AMP
25