Table of Contents
Advertisement
Encore Profile Pro WW
Listed below are a few common problems the user may encounter, with solutions.
Unit not powered on:
•
Check that the fixture is plugged in.
Unit not responding to DMX:
•
Check that the DMX cables are connected properly and are wired correctly (pin 3 is "hot"; on
some other DMX devices pin 2 may be 'hot'). Also, check that all cables are connected to the right
connectors; it does matter which way the inputs and outputs are connected.
Encore Profile Pro WW
DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE!
CLEANING
Frequent cleaning is recommended to ensure proper function, optimized light output, and an
extended life. The frequency of cleaning depends on the environment in which the fixture operates:
damp, smoky, or particularly dirty environments can cause greater accumulation of dirt on the fixture's
optics. Clean the external lens surface periodically with a soft cloth to avoid dirt/debris accumulation.
NEVER use alcohol, solvents, or ammonia-based cleaners.
Encore Profile Pro WW
MAINTENANCE
Regular inspections are recommended to ensure proper function and extended life.
There are no user serviceable parts inside this fixture, please refer all other service issues to an
authorized ADJ service technician. Should you need any spare parts, please order genuine parts from
your local ADJ dealer.
Please refer to the following points during routine inspections:
-
A detailed electrical check by an approved electrical engineer every three months, to make sure the
circuit contacts are in good condition in order to prevent overheating.
-
Be sure all screws and fasteners are securely tightened at all times. Loose screws may fall out during
normal operation, resulting in damage or injury as larger parts could fall.
-
Check for any deformations on the housing, color lenses, rigging hardware, and rigging points
(ceiling, suspension, trussing). Deformations in the housing could allow for dust or liquids to enter
into the fixture. Damaged rigging points or unsecured rigging could cause fixture to fall and
seriously injure a person(s).
-
Electric power supply cables must not show any damage, material fatigue, or sediments.
-
NEVER remove the ground prong from the power cable.
2 7
Troubleshooting
Cleaning
Maintenance
Advertisement
Table of Contents
