ADJ ENCORE PROFILE PRO WW User Instructions page 15

Encore Profile Pro WW System Menu
DMX Address - In this menu you can find and set your desired DMX address.
Channel Mode - In this menu you can find and set your desired DMX channel mode.
Function Status - This menu setting is used as a precaution mode in case the DMX signal is lost or
interrupted. The operating mode chosen in this menu is the running mode the fixture will go into when
the DMX signal is lost. Listed below are the 3 modes.
• Hold - This setting will have the fixture stay in the last DMX setup.
• Black - This setting will have the fixture automatically go into stand by mode.
LCD Set - In this menu you are able to activate/deactivate the display blackout and activate/deactivate the dis‐
play lock.
Temp.C/F - Set temperature display between Celsius and Fahrenheit.
Dim Mode - In this menu you are able to select your desired dimmer mode and adjust the dimming
speed time.
Disp. Set - In this menu you are able to activate/deactivate the display blackout and activate/deactivate the dis‐
play lock.
Dim Curve - Set Dimming Curve
Frequen - Set fixture frequency.
MasterSW- This transmits the DMX signal via a master & slave control hierarchy.
Service - In this menu you are able to access and adjust/change: the calibration (effect adjust) and
restore the factory settings.
USB_Data - Turns USB data access on or off.
DFSE - Turns Default Setting on or off.
Time Info - Select between Current fixture running time and Fixture total running time. Only the Fix‐
ture Current fixture running time can be cleared
TempInfo - Displays fixture temperature.
Err.Info - Displays fixture error information.
ModelInf - Displays fixture information.
Software - Displays current software version.
ManCTRL - Manual Dimmer Control.
Strobe=XXXX - Test Strobe Effect.
Calibrate - Calibrate LED, password protected.
1 5