Nibe F1145 Series Installation Manual page 63

start updating
Select "start updating" if you want to start the update.
You are asked whether you really want to update the
software. Respond "yes" to continue or "no" to undo.
If you responded"yes" to the previous question the up-
date starts and you can now follow the progress of the
update on the display. When the update is complete
F1145 restarts.
TIP
A software update does not reset the menu
settings in F1145.
Caution
If the update is interrupted before it is com-
plete (for example power cut etc.), the soft-
ware can be reset to the previous version if
the OK button is held in during start up until
the green lamp starts to illuminate (takes about
10 seconds).
choose another file
update firmware7.1
Select "choose another file" if you do not want to use
the suggested software. When you scroll through the
files, information about the marked software is shown
in a fact box just as before. When you have selected a
file with the OK button you will return to the previous
page (menu 7.1) where you can choose to start the up-
date.
Menu 7.2 - logging
activated
interval
Setting range: 1 s – 60 min
Factory setting range: 5 s
NIBE F1145
logging7.2
5
sec
Here you can choose how current measurement values
from F1145 should be saved onto a log file on the USB
memory.
Set the desired interval between loggings.
1.
2. Tick "activated".
3. The present values from F1145 are saved in a file
in the USB memory at the set interval until "activ-
ated" is unticked.
Caution
Untick "activated" before removing the USB
memory.
Logging floor drying
Here you can save a floor drying log on the USB memory
and in this way see when the concrete slab reached the
correct temperature.
• Make sure that "floor drying function" is activated in
menu 5.9.
• Select "logging floor drying activated".
• A log file is now created, where the temperature and
the immersion heater output can be read off. Logging
continues until "logging floor drying activated" is
deselected or until "floor drying function" is stopped.
Caution
Deselect "logging floor drying activated" before
you remove the USB memory.
Chapter 9 | Service 63