2. Install the
bottom
cover.
3. Install the
system-board
4. Install the
back
cover.
5. Install the
cable cover
(optional).
6. Install the stand.
7. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
cable cover
4. Remove the
back
cover.
5. Remove the
system-board
6. Remove the
bottom
cover.
7. Remove the
rear-I/O
bracket.
8. Remove the speakers.
About this task
The following image provides a visual representation of the power-button board removal procedure.
Steps
1. Open the latch and disconnect the power-button board cable from the connector on the system board.
2. Unroute the power-button board cable from the display-assembly base, then slide the power-button board cable out from under the
antenna cables.
3. Remove the screw (M3x5) that secures the power-button board to the middle frame.
4. Lift the power-button board, along with its cable, off the middle frame.
70
Removing and installing components
shield.
After working inside your
computer.
Before working inside your
(optional).
shield.
computer.