Installing The Camera Assembly - Dell OptiPlex 7480 All-In-One Service Manual

3. Unroute the camera cable from the routing guides on the display-assembly base.
4. Remove the two screws (M3x5) that secure the camera assembly to the middle frame.
5. Slide and remove the camera assembly from the middle frame.

Installing the camera assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the camera assembly and provides a visual representation of the installation procedure.
Steps
1. Slide the camera assembly on the middle frame, and align the screw holes on the camera assembly with the screw holes on the middle
frame.
2. Replace the two screws (M3x5) to secure the camera assembly to the middle frame.
3. Route the camera cable through the routing guides on the display-assembly base.
4. Connect the camera cable to the system board.
5. Align the screw holes on the camera door with the screw holes on the display-assembly base.
42 Removing and installing components