Stand; Removing The Fixed Stand; Installing The Fixed Stand - Dell OptiPlex 7480 All-In-One Service Manual

Stand

Removing the fixed stand

Prerequisites
1. Follow the procedure in
NOTE: When servicing the system, place it on an elevated, clean, and flat surface. Dell recommends removing the stand
to avoid accidental damage to the system display during servicing.
About this task
The following image provides a visual representation of the fixed stand removal procedure.
Steps
1. Press and slide the release button up.
2. Hold the button in the release position and lift the stand upward.
3. Slide the stand downward, to lift the stand off the back cover.

Installing the fixed stand

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
12 Removing and installing components
Before working inside your computer.