Table of Contents
Advertisement
3. TECHNICAL DESCRIPTION
3.1 Connection of the load cell to indicator
3.2 Connection of RS232 to PC or Printer
4. STANDARD OPERATIONS
Make sure the equipment connected correctly and parameters set well, and also the scale has already been
calibrated correctly.
Configuration and Calibration – consult the authorized personnel.
4.1 On/Off
Press
On/Off to switch on the scale and it will display 0.00 after self-checking display
Press
On/Off for 2 seconds to turn off the indicator
4.2 Zero/Tare
4.2.1 If the display is not 0 after power on, press TARE/Zero to zero the scale (<2%F.S.)
4.2.2 Weighing with something on the platform together, put the chair or container on the scale (>2%F.S.)
and press TARE/Zero to make a tare and get subtract of the weight of the container.
4.2.3 Remove the tare: remove the object and press
scale.
4.2.4 Long press
TARE/Zero to zero the scale is the scale not display zero after all removed from the
platform.
4.3
Units Exchange
Press
UNIT/Weight for 2 seconds to exchange the weight units (Kg-lb or lb-Kg)
!
INDICATOR
+E (1)
-E (5)
+S (7)
-S (8)
GND (3) ------------- (GND) shield
INDICATOR
1
---------------- TX
2
---------------- SC
3
---------------- GND
4
---------------- SC
!
TARE/Zero to clear the tare value and zero the
LOAD CELL
------------- +Excitation
------------- -Excitation
------------- +Signal
------------- -Signal
PC/PRINTER
5!
Advertisement
Table of Contents
