Dome Cover - Axis Q60-E Series Installation Manual

AXIS Q60-E Series
• Do not attempt to repair the product yourself. Contact Axis support or your Axis reseller
for service matters.
• Do not point the camera lens toward the sun or other high-intensity radiation sources
because this could cause damage to the camera.
• The power supply shall be plugged in to a socket outlet installed near the product and
shall be easily accessible.
• Use a limited power source (LPS) with a rated output power limited to ≤100 W and a rated
output current limited to ≤5 A.
Transportation
NO NO TICE NO TICE TICE
• When transporting the Axis product, use the original packaging or equivalent to prevent
damage to the product.
Battery
The Axis product uses a 3.0 V CR2032 lithium battery as the power supply for its internal real-time
clock (RTC). Under normal conditions this battery will last for a minimum of five years.
Lithium coin cell 3.0 V batteries contain 1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.

Dome cover

NO NO TICE NO TICE TICE
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
• Do not clean a dome cover that looks clean to the eye and never polish the surface.
Excessive cleaning could damage the surface.
• For general cleaning of the dome cover it is recommended to use a non-abrasive,
solvent-free neutral soap or detergent mixed with pure water and a soft, clean cloth. Rinse
well with pure lukewarm water. Dry with a soft, clean cloth to prevent water spotting.
• Never use harsh detergents, gasoline, benzene, acetone, or similar chemicals.
• Avoid cleaning the dome cover in direct sunlight or at elevated temperatures.
• Make sure the dome is attached in operation mode, otherwise focus may be affected.
6