Dome Cover - Axis M4206-V Installation Manual

Hide thumbs Also See for M4206-V:
Table of Contents

Advertisement

English
Safety instructions
WARNING
IR emitted from this product. Do not stare at
operating lamp.
NO TICE
TICE
NO
NO
TICE
The Axis product shall be used in compliance
with local laws and regulations.
Axis recommends using a shielded network cable
(STP).
To use the Axis product outdoors, or in similar
environments, it shall be installed in an approved
outdoor housing.
Store the Axis product in a dry and ventilated
environment.
Avoid exposing the Axis product to shocks or
heavy pressure.
Do not install the product on unstable poles,
brackets, surfaces or walls.
Use only applicable tools when installing the Axis
product. Using excessive force with power tools
could cause damage to the product.
Do not use chemicals, caustic agents, or aerosol
cleaners.
Use a clean cloth dampened with pure water for
cleaning.
Use only accessories that comply with the
technical specification of your product. These
can be provided by Axis or a third party. Axis
recommends using Axis power source equipment
compatible with your product.
Use only spare parts provided by or recommended
by Axis.
Do not attempt to repair the product yourself.
Contact Axis support or your Axis reseller for
service matters.
The power supply shall be plugged in to a socket
outlet installed near the product and shall be
easily accessible.
Use a limited power source (LPS) with either a
rated output power limited to ≤100 W or a rated
output current limited to ≤5 A.
Transportation
NO TICE
TICE
NO
NO
TICE
When transporting the Axis product, use the
original packaging or equivalent to prevent
damage to the product.
Battery
Low battery power affects the operation of the RTC,
causing it to reset at every power-up. When the
battery needs replacing, a log message will appear
in the product's server report. For more information
about the server report, see the product´s web page
or contact Axis support.
Lithium coin cell 3.0 V batteries contain
1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
WARNING
Risk of explosion if the battery is incorrectly
replaced.
The battery should be replaced with an identical
battery only.
Used batteries should be disposed of according
to local regulations or the battery manufacturer's
instructions.

Dome cover

NO
NO TICE
NO
TICE
TICE
Be careful not to scratch, damage or leave
fingerprints on the dome cover because this
could decrease image quality. If possible, keep
the protective plastic on the dome cover until
the installation is complete.
Do not clean a dome cover that looks clean to
the eye and never polish the surface. Excessive
cleaning could damage the surface.
For general cleaning of the dome cover it is
recommended to use a non-abrasive, solvent-free
neutral soap or detergent mixed with pure water
and a soft, clean cloth. Rinse well with pure
lukewarm water. Dry with a soft, clean cloth to
prevent water spotting.
Never use harsh detergents, gasoline, benzene,
acetone, or similar chemicals.
Avoid cleaning the dome cover in direct sunlight
or at elevated temperatures.
Français
Consignes de sécurité
AVERTISSEMENT
IR émis par ce produit. Ne jamais fixer la
lampe en fonctionnement.
A A A VIS
VIS
VIS
Le produit Axis doit être utilisé conformément
aux lois et règlements locaux.
Axis recommande d'utiliser un câble réseau
blindé (STP) CAT5 ou supérieur.
Pour pouvoir utiliser le produit Axis à l'extérieur,
ou dans des environnements similaires, il doit être
installé dans un boîtier d'extérieur homologué.
Conserver ce produit Axis dans un environnement
sec et ventilé.
Ne pas exposer ce produit Axis aux chocs ou aux
fortes pressions.
Ne pas installer ce produit sur des poteaux,
supports, surfaces ou murs instables.

Advertisement

Table of Contents
loading

This manual is also suitable for:

M42 seriesM4206-lv01240-001

Table of Contents