Axis Q60 Series Preventive Maintenance Instructions And Checklist
Hide thumbs
Also See for Q60 Series:
- Installation manual (105 pages) ,
- User manual (29 pages) ,
- Repainting instructions (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Axis Q60 Series
Summary of Contents for Axis Q60 Series
- Page 1 AXIS PTZ Camera Preventive Maintenance Instructions and Checklist...
- Page 2 Introduction Introduction AXIS PTZ cameras are designed for long-lasting operation. To minimize the effects of exterior conditions (for example, weather and wear), to avoid problems, and to keep the expected operation levels (performance and product life), the PTZ camera, and the operation of it, will benefit from regular maintenance.
-
Page 3: Safety Instructions
• Do not use chemicals, caustic agents, or aerosol cleaners. Use a clean cloth dampened with pure water for cleaning. • Use only accessories that comply with technical specification of the device. These can be provided by Axis or a third party. -
Page 4: Firmware Maintenance
If the counter is above the (x) value but the camera still functions normally, use it as normal while observing its behavior. and the camera is not functioning to your satisfaction, contact Axis support axis.com/support to open a case for maintenance. - Page 5 If the preset accuracy offset is high, go to Settings > PTZ > Limits and turn off E-flip. • If the offset is still higher than 0.5°C after completing the actions above, contact axis.com/support. PTZ test Purpose: Test the PTZ mechanism. The built-in PTZ test is designed to calibrate the camera block and check for problems.
-
Page 6: Latest Firmware
Using firmware from the active track is recommended if you want to access the newest features, or if you use Axis end-to-end system offerings. The LTS tracks are recommended if you use third-party integrations, which are not continuously validated against the latest active track. - Page 7 See the device’s installation guide on how to replace the dome cover. • A replacement dome cover can be ordered as a spare part by an Axis reseller. Screws Purpose: Keep the camera protected against incidents and maintain the IP rating.
- Page 8 • Inspect the bracket and remove insects and dirt. • If the camera is installed on an Axis bracket, we recommend installing AXIS T91A6 Pipe Seal inside the bracket. This increases the level of protection against insects. Cabling (ethernet) Purpose: Avoid network and camera problems, for example power drops, by making sure that the cabling meets the requirements of your equipment.
- Page 9 The plastic network connector shield. Both the connector and the premounted cable are available from an Axis reseller. Instructions for mounting the IP66 connector: axis.com/support/faq/FAQ116166 Outer heat sink – valid for cold models (-C) only...
- Page 10 AXIS PTZ Camera Instructions 4. When the pressure inside the camera housing reaches 0.5 bar (7 psi) the pressure relief valve will open. Place your hand over the pressure relief valve to verify that the gas is flowing out. 5. Lift the pressure relief valve to let the overpressure out of the camera unit.
- Page 11 Cabling (ethernet) ˜P ˜N/P ˜N/A RJ45 push-pull connector (IP66) ˜P ˜N/P ˜N/A Outer heat sink (only Q60-C) ˜P ˜N/P ˜N/A Pressurize (only Q60-S) ˜P ˜N/P ˜N/A Contacted Axis support on item(s) ______________________________________________ Online helpdesk case numbers on item(s) _________________________________________ Signature ___________________________...
- Page 12 Ver. M1.8 AXIS PTZ Camera Date: May 2021 © Axis Communications AB, 2021 Part No. T10168211...