32) Ang. max - Maximum angle:
T/in or T/lv (see T&A specific instructions). The maximum angle the operator can set is 9720°.
When T&A is set on Ang., A/in or A/lv mode, maximum angle corresponds to the angle that has to be
carried out.
SEQUENCE MENU:
- - - S E Q U E N C E - M E N U - - - -
O K
1 ) S e q
2 ) S e q u e n c e :
1) Seq set:
you can set a sequence up to max. 8 programs.
To set the next program in the sequence, press OK.
Press
to save the sequence and quit.
2) Sequence:
to enable or disable the sequence. ON = enabled; OFF = disabled.
- - - S E Q U E N C E - M E N U - - - -
3 ) E x t
4 ) M o d .
5 ) I n s .
3) Ext box:
It allows to enable or disable the external switch box. ON = switch box enabled; OFF = switch
box disabled.
4) Barc. mode: – Barcode mode
OFF:
barcode disabled.
ON prog:
you can select the program to be executed by scanning the bar code of the product. The
unit compares the scanned code to the one previously entered in each program (see point 27: Barc.
Set.). If the two codes match, the program is loaded; otherwise it will display Error Barcode. The
scanned product code is also printed on the serial port of the control unit (see paragraph "serial
print").
ON S.N.:
the product code is required before running a program or a sequence. The product code is
printed on the serial port of the control unit.
ON Seq.
: you can set the Sequence by scanning its barcode.
the sequence entered in the menu (see point 5: Ins. Barcode Seq on Menu Sequence). If the
two codes match, the sequence set is loaded, otherwise display
code is also printed on the serial port of the control unit (see section Serial Print).
5) Ins. Barcode Seq:
When ON on "Barc. Mode → ON Seq.", you have to scan the barcode to enable the
Sequence.
- - - S E Q U E N C E - M E N U - - - -
6 ) R e s e t
7 ) R e s e t
Maximum angle threshold. You can set it when T&A is set on Tor,
c h a n g e
s e t :
b o x :
b a r c :
b a r c o d e
: It allows to choose the barcode mode.
S e q . :
S e q .
E S C
q u i t
1 4 7 3 9 8 1 2
o f f
O F F
O F F
S e q
The code scanned is compared with
Repeat scan
"
ON
A u t : ON
. The read
"
Page 9
Need help?
Do you have a question about the EDU 2AE/TOP/NT and is the answer not in the manual?