IBM Power System System E950 Manual page 51

e) Select Hot Plug Task > PCI Hot Plug Manager > Configure a defined device.
f) Select the device that you replaced from the list, and then press Enter. The device is now
configured.
g) Press the F10 key to exit the diagnostic program.
10. If you are using the AIX operating system, complete the following steps to verify the PCIe adapter
replacement:
a) If the diagnostic menu is not displayed, type the diag command.
b) Select Advance Diagnostic Routines > Problem Determination.
c) Select the name of the resource that was replaced from the menu. If the resource replaced is not
shown, choose the resource that is associated with it.
d) Press Enter, and then press Commit (F7 or Esc+7).
e) Did the Problem Determination identify any problems?
• No: Continue to the next step.
• Yes: A problem is identified.
– If you are a customer, record the error information, and then contact your service provider.
– If you are an authorized service provider, return to map 210-5.
f) Press the F10 key to exit the diagnostic program.
g) Continue with step "12" on page 37.
11. If you are using the Linux operating system, complete the following steps:
a) In the Linux session on the console, press Enter after you install or replace the adapter to put the
slot into the action state.
b) Enter the slot information with the lsslot command, as shown in the following example.
For example, if the slot in which you installed the PCIe adapter was U7879.001.DQD014E-P1-C3.
Enter lsslot -c pci -s U7879.001.DQD014E-P1-C3
The following screen is an example of the information that is displayed by this command:
# Slot
U7879.001.DQD014E-P1-C3 PCI-X capable, 64 bit, 133MHz slot 0001:40:01.0
12. Verify the installed part.
• If you replaced the part because of a service action, verify the installed part. For instructions, see
https://www.ibm.com/support/knowledgecenter/POWER9/p9ect/
pxect_verifyrepair.htm (www.ibm.com/support/knowledgecenter/POWER9/p9ect/
pxect_verifyrepair.htm).
• If you installed the part for any other reason, verify the installed part. For instructions, see https://
www.ibm.com/support/knowledgecenter/POWER9/p9haj/pxhaj_hsmverify.htm (www.ibm.com/
support/knowledgecenter/POWER9/p9haj/pxhaj_hsmverify.htm).
13. Turn off the identify LED. For instructions, see Deactivating an identify LED (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_turn_off_identify_led.htm).
14. If you replaced a Fibre Channel adapter, the customer might need to update the Fibre Channel SAS
path to the external storage subsystems with the new WWPN number or numbers.
Description
Installing, removing, and replacing PCIe adapters in the 9040-MR9 system 37
Device(s)