IBM Power System System E950 Manual page 21

Where locationcode is the location of the PCIe slot. For example, the location might be
U7879.001.DQD014E-P1-C3.
2) Press Enter. A fast-flashing amber LED at the rear of the system near the adapter indicates that
the slot is identified.
3) Physically verify that the slot you identified is where you want to install the adapter.
Notes:
• Use the blue identify LED on the enclosure to locate the system. Ensure that the serial
number of the system matches the serial number to be serviced.
• Look for the flashing amber LED, which identifies the slot that was selected by using the
identify function.
e) Physically verify that the slot you identified is where you want to install the adapter.
• Use the blue identify LED on the enclosure to locate the system. Ensure that the serial number
of the system matches the serial number to be serviced.
• Look for a flashing amber LED, which identifies the unoccupied slot that was selected by using
the identify function.
11. At the rear of the system, put the cable management bracket in the service position. See the
following figure.
a) Pull out the quarter-turn fasteners (B) and turn them to disengage them while you lift the cable
management bracket (A) to its raised position.
b) Turn the quarter-turn fasteners (B) to engage and lock the bracket into position.
Installing, removing, and replacing PCIe adapters in the 9040-MR9 system 7